20-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - VLAN Mode
no commands
no port-dot1q
Use the VLAN no port-dot1q command to disable dot1q tagging for the port. By default, VLAN
tagging is disabled on a LAN port. In this default state, if the port receives a VLAN tagged frame,
it will ignore the VLAN header and will process the ingress frames as a regular Ethernet frame. The
VLAN tag will not be altered.
Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a
port forwarding frames to another port(s) in the switch.
To set the port to VLAN aware mode, see port-dot1q command on page 20-5.
Syntax: (config-vlan)# no port-dot1q ethernet port
Example: (config-vlan)# no port-dot1q ethernet 1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no vlan
Use the VLAN no vlan command to clear a VLAN entry.
Syntax: (config-vlan)# no vlan entry
Example: (config-vlan)# no vlan 2
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 and MSR: 1.1 and 2.1
Field Definition
entry VLAN entry. Range = 2 - 4094.
To Next Page
Loading...