Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Commands; No Static-Lease

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 7-5
Configuration - DHCP Pool Ethernet Mode
no commands
no option
Use the DHCP Pool no option command to delete a DHCP option. To add a DHCP pool, see
option command on page 7-6.
Syntax: (config-dhcp-eth-{n})# no option {66|67}
Example: (config-dhcp-eth-1)# no option 66
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no relay
Use the DHCP Pool no relay command to disable DHCP relay. To enable relay, see
relay command on page 7-6.
Syntax: (config-dhcp-eth-{n})# no relay
Example: (config-dhcp-eth-1)# no relay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no static-lease
Use the DHCP Pool no static-lease command to remove a static DHCP lease. To add a static lease,
see static-lease command on page 7-7.
Syntax: (config-dhcp-eth-{n})# no static-lease ip-address address
Example: (config-dhcp-eth-1)# no static-lease ip-address 10.10.2.100
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
66 Remove/Disable option 66 (TFTP server name).
67 Remove/Disable option 67 (Boot file name).
Field Definition
address Enter the IP address of the static lease to remove.