Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Commands

14-12 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - IPSec Mode
no commands
no aggressive-mode
Use the IPSec mode no aggressive-mode command to set to main mode, instead of aggressive mode.
To set to aggressive mode, see aggressive-mode command on page 14-2.
Syntax: (config-ipsec {n})# no aggressive-mode
Example: (config-ipsec-1)# no aggressive-mode
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no dpd-delay
Use the IPSec no dpd-delay command to reset the Dead Period Detection (DPD) delay back to the
default settings. To set the DPD delay, see dpd-delay command on page 14-4.
Syntax: (config-ipsec-{n})# no dpd-delay
Example: (config-ipsec-1)# no dpd-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no dpd-enable
Use the IPSec no dpd-enable command to disable Dead Period Detection (DPD). To enable DPD, see
dpd-enable command on page 14-4.
Syntax: (config-ipsec-{n})# no dpd-enable
Example: (config-ipsec-1)# no dpd-enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no dpd-timeout
Use the IPSec no dpd-timeout command to set the Dead Period Detection (DPD) timeout to the default
setting. To set DPD timeout, see dpd-timeout command on page 14-4.
Syntax: (config-ipsec-{n})# no dpd-timeout
Example: (config-ipsec-1)# no dpd-timeout
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR