Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Network-Object; Nat-Bypass

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-35
Global Configuration Mode
Global Configuration Commands
nat-bypass
Use the nat-bypass command to create and enable a NAT bypass rule. To disable NAT Bypass, see no
nat-bypass command on page 4-44.
Syntax: (config)# nat-bypass ip-address address mask mask [enable]
Example: (config)# nat-bypass ip-address 10.10.2.1 mask 255.255.255.0
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
network-object
Use the network-object command to configure a network object with the system. To delete a network
object, see no network-object command on page 4-45.
Syntax: (config)# network-object id object-id description text type
{hostname hostname|ip-address address|mac-address mac-address}
Example: (config)# network-object id 1 description Unit1 type ip-address
192.168.1.200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter a NAT bypass IP address.
mask Enter a subnet mask for the above address.
enable Enable NAT bypass.
Note: To create the rule without enabling, do not enter this option.
Field Definition
object-id Enter the numerical ID for the Network Object.
text Enter a description of the Network Element.
hostname Enter the host name of the Network Object.
address Enter the IP address of the Network Element.
mac-address Enter the MAC address of the Network Element (xx:xx:xx:xx:xx:xx)