Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Schedule-Availability

11-22 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Ethernet Interface Mode
no remote-admin
Use the Ethernet Interface no remote-admin command to disable remote access on this interface.
To enable remote access, see remote-admin command on page 11-23.
Syntax: (config-int-eth-{n})# no remote-admin
Example: (config-int-eth-1)# no remote-admin
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no schedule-availability
Use the Ethernet Interface no schedule-availability command to disable a schedule rule. To create
a rule, see schedule-availability command on page 11-24.
Syntax: (config-int-eth-{n})# no schedule-availability
Example: (config-int-eth-1)# no schedule-availability
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no shutdown
Use the Ethernet Interface no shutdown command to set the Ethernet port up (In-Service). To set
the Ethernet port down (Out-of-Service), see shutdown command on page 11-24.
Syntax: (config-int-eth-{n})# no shutdown
Example: (config-int-eth-2)# no shutdown
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no sip-alg
Use the Ethernet Interface no sip-alg command to disable SIP ALG on this interface. To enable sip
alg, see sip-alg command on page 11-24.
Syntax: (config-int-eth-{n})# no sip-alg
Example: (config-int-eth-1)# no sip-alg
Supported Platforms:
Adit 3104, Adit 3500, MSR