CHAPTER
17
Configuration - PPTPC Mode
The PPTPC Configuration commands allow the user to configure the VPN (Virtual Private Network)
Point-to-Point Tunneling Protocol Client parameters.
Enter this sub-group with the (config)# pptpc command from the Configuration mode.
The VPN PPTPC commands are represented by the (config-pptpc-n)# prompt.
PPTP Client Commands
• do • ip primary-dns
• end • ip rip
• exit • ip route
• firewall • ip route-mode
• history • ip secondary-dns
• host-ip • metric
• ip address • no commands
• ip default-route • ppp authentication
• ip mtu • ppp encryption
• ip ospf authentication • ppp exec-timeout
• ip ospf authentication-key • ppp on-demand
• ip ospf cost • ppp password
• ip ospf dead-interval • ppp restart-timer
• ip ospf disable • ppp time-btwn-reconnect
• ip ospf hello-interval • ppp username
• ip ospf message-digest-key • schedule-availability
• ip ospf priority • shutdown
• ip ospf retransmit-interval • sip-alg
• ip ospf transmit-delay
To Next Page
Loading...