Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Radius-Client; Remote-Admin

4-54 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
radius-client
Use the radius-client command to allow access to the RADIUS configuration commands. See Chapter
19, Configuration - RADIUS Mode for commands in this mode. For the no counterpart of this command,
see no radius-client command on page 4-46.
Syntax: (config)# radius-client
Example: (config)# radius-client
(config-radius)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
remote-admin
remote-admin icmp
Use the remote-admin icmp command to allow ICMP echo requests (pings). To deny ICMP echo
requests, see no remote-admin icmp command on page 4-46.
CAUTION! ALLOWING REMOTE ADMINISTRATION IS A SECURITY RISK.
Syntax: (config)# remote-admin icmp enable
Example: (config)# remote-admin icmp enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
remote-admin snmp
Use the remote-admin snmp command to allow SNMP control and diagnostic requests. To deny
SNMP, see no remote-admin snmp command on page 4-46.
CAUTION! ALLOWING REMOTE ADMINISTRATION IS A SECURITY RISK.
Syntax: (config)# remote-admin snmp enable
Example: (config)# remote-admin snmp enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR