Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - 6 Configuration - T1 Controller Mode; Description; Ds0-Group; End

To Next Page

To Previous Page

CHAPTER

Configuration - T1 Controller Mode

The T1 Controller Configuration commands allow the user to configure the T1 parameters on the Adit

3000 series.

Note: The T1 Controller Configuration mode is supported by the Adit 3000 series only. For Controller

Configuration commands for the MSR card, see Chapter 5, Configuration - LCC Controller Mode.

This sub-group is entered with the (config)# controller t1 command from the Configuration mode.

The T1 Controller commands are represented by the (config-cont-t1-{n})# prompt.

T1 Controller Commands

• description • lbo

• do • linecode

• ds0-group • loopback

• end • loopdetect

• exit • no commands

•fdl •pri-group

• framing • shutdown

•history •tdm-group

• idle-pattern • threshold