Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-23
Configuration - Multilink Interface Mode
ppp qos-interleaving
Use the Multilink Interface ppp qos-interleaving command enable PPP Quality of Service
Interleaving. To disable PPP QoS Interleaving, see no ppp qos interleaving command on page 12-19.
Syntax: (config-int-mlink-{n})# ppp qos-interleaving
Example: (config-int-mlink-1)# ppp qos-interleaving
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ppp restart-timer
Use the Multilink Interface ppp restart-timer command to configure the PPP restart timer.
Syntax: (config-int-mlink-{n})# ppp restart-timer seconds
Example: (config-int-mlink-1)# ppp restart-timer 15
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ppp time-btwn-reconnect
Use the Multilink Interface ppp time-btwn-reconnect command configure the time between reconnect
attempts.
Syntax: (config-int-mlink-{n})# ppp time-btwn-reconnect seconds
Example: (config-int-mlink-1)# ppp time-btwn-reconnect 15
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
enable Enable IP TOS marking.
Field Definition
seconds Set the interval of time between reconnect attempts.
Range is 0 - 99999 seconds. Default is 30 seconds.
To Next Page
Loading...