Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Snmp-Server Host; Snmp-Server Traps Enable; Snmp-Server Trusted-Ip

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-61
Global Configuration Mode
Global Configuration Commands
snmp-server host
Use the snmp-server host command to set a SNMP host.
Syntax: (config)# snmp-server host address {community
community-name|version {1|2c}
Example: (config)# snmp-server host 192.168.1.1 version 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
snmp-server traps enable
Use the snmp-server traps enable command to enable SNMP traps on the system. To delete a
SNMP server trap, see no snmp-server traps command on page 4-50.
Syntax: (config)# snmp-server traps enable
Example: (config)# snmp-server traps enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
snmp-server trusted-ip
Use the snmp-server trusted-ip command to set a SNMP trusted peer (The IP address, or subnet
address that identifies which remote management stations are allowed to perform SNMP
operations).
Syntax: (config)# snmp-server trusted-ip {address|any}
[trusted-mask mask]
Example: (config)# snmp-server trusted ip any
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter an destination IP address.
community-name Enter the SNMP community name.
version 1 - SNMPv1
2c - SNMPv2c
Field Definition
address Enter an IP address of a trusted peer.
any Allow any IP address trusted peer access.
trusted-mask mask This is an optional parameter, enter the subnet mask of the trusted peer
IP address.