3-54 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Privileged Mode
show running-config
Use the show running-config command to display the current configuration of the system.
Syntax: # show running-config
Example: adit 3500# show running-config
ip host adit3500
log system notify none
log security notify none
log t1 notify none
clock source 1 t1 1
clock source 2 none
controller t1 1
description T1 #1
lbo short 133
fdl none
framing esf
linecode b8zs
loopdetect none
loopback none
idle-pattern 0x7f
no pri-group
no tdm-group
no ds0-group
.
.
.
interface ethernet 1
ip address 192.168.1.150 mask 255.255.255.0
description LAN Hardware Ethernet Switch
ip mtu auto
no tos ip
tos ip 0x0
no ip primary-dns
no ip secondary-dns
no ip default-route
no ip proxy-arp
no ip rip
ip rip receive-version 1or2
ip rip send-version 2-bcast
no sip-alg
no firewall
metric 50
no shutdown
speed auto
full-duplex
remote-admin enable
no schedule-availability
.
.
.
ip dhcp pool ethernet 1
start 192.168.1.1
end 192.168.1.244
subnet-mask 255.255.255.0
lease 60
ip dhcp pool ethernet 2
no dhcp pool
To Next Page
Loading...