3-24 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Privileged Mode
show config controller t1
Use the show config controller t1 command to display the T1 information.
Syntax: # show config controller t1 port
Example: adit 3500# show config controller t1 1
controller t1 1
description T1 1
lbo short 133
fdl none
framing esf
linecode b8zs
loopdetect none
loopback none
idle-pattern 0x7f
no pri-group
no tdm-group
ds0-group timeslots 1-24
threshold daily ses 0
threshold daily sefs 0
threshold daily uas 0
threshold daily css 0
threshold daily les 0
threshold daily bes 0
threshold daily dm 0
threshold daily lcv 0
threshold daily pcv 0
threshold daily es 0
threshold min15 ses 0
threshold min15 sefs 0
threshold min15 uas 0
threshold min15 css 0
threshold min15 les 0
threshold min15 bes 0
threshold min15 dm 0
threshold min15 lcv 0
threshold min15 pcv 0
threshold min15 es 0
no shutdown
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
Field Definition
port T1 port to display.
Adit 3104: Value must be 1.
Adit 3500: Range 1 - 4.
To Next Page
Loading...