Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Dpd-Enable; Dpd-Timeout

14-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - IPSec Mode
dpd-delay
Use the IPSec dpd-delay command to set the Dead Period Detection delay. To set the DPD delay back
to the default settings, see no dpd-delay command on page 14-12.
Syntax: (config-ipsec {n})# dpd-delay seconds
Example: (config-ipsec-1)# dpd-delay 200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
dpd-enable
Use the IPSec dpd-enable command to enable Dead Period Detection (DPD). To disable DPD, see no
dpd-enable command on page 14-12.
Syntax: (config-ipsec {n})# dpd-enable
Example: (config-ipsec-1)# dpd-enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
dpd-timeout
Use the IPSec dpd-timeout command to set the Dead Period Detection (DPD) timeout period. To reset
DPD timeout to default setting, see no dpd-timeout command on page 14-12.
Syntax: (config-ipsec {n})# dpd-timeout seconds
Example: (config-ipsec-1)# dpd-timeout
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
seconds Set the delay time in seconds. Range 1-3600 seconds, with a default of
60.
Field Definition
seconds Set the timeout period in seconds. Range 1-9999 seconds, with a
default of 120.