Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Dmz-Host; Dial-Peer Voice Voip

4-12 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
dial-peer voice voip
Use the dial-peer voice voip command to allow access to the Dial Peer Voice VoIP configuration
commands. See Chapter 10, Configuration - Dial Peer VoIP Mode for commands in this mode. For
the no counterpart of this command see no dial-peer voice voip command on page 4-39.
Syntax: (config)# dial-peer voice voip trunk
Example: (config)# dial-peer voice voip 1
(config-dpeer-voip)#
Supported Platforms:
Adit 3104, Adit 3500, MSR
dmz-host
Use the dmz-host command to configure the DMZ host. To remove a DMZ host, see no dmz-host
command on page 4-39.
Syntax: (config)# dmz-host address enable
Example: (config)# dmz-host 10.10.200.1 enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
trunk Enter trunk number. Range is 1-50.
Field Definition
address The IP address of the DMZ host.