6-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - T1 Controller Mode
history
Use the history command to display commands that have been entered in this session. This command
can be entered in any configuration mode.
Syntax: (config-cont-t1-{n})# history
Example: (config-cont-t1-1)# history
history
framing d4
threshold daily lcv
threshold d
threshold daily pcv
threshold daily bes
threshold daily css
threshold daily uas 1000
history
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
idle-pattern
Use the Controller T1 idle-pattern command to set the idle pattern on the designated T1.
Syntax: (config-cont-t1-{n})# idle-pattern number
Example: (config-cont-t1-1)# idle-pattern 0x7f
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
number A hexadecimal number with a range from 0x00 to 0xff. This number
must be preceeded by 0x. Default 0x7f.
To Next Page
Loading...