Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Transform-Set

14-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - IPSec Mode
transform-set
Use the IPSec transform-set command to set the allowable encryption methods, authentication
protocols and to enable compression during automatic key exchange. To disable encryption/
authentication/compression, see no transform-set command on page 14-16.
Syntax: (config-ipsec-{n})# transform-set {ah-md5|ah-sha|esp-3des| esp-
aes|esp-aes192|esp-aes256|esp-des|esp-md5|esp-null|esp-sha
|ipcomp}
Example: (config-ipsec-1)# transform-set esp-aes
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
ah-md5 Authentication Header transform using MD5 authentication. Default.
ah-sha Authentication Header transform using Secure Hash Algorithm
(SHA1) authentication. Default.
esp-aes Encapsulating Security Payload (ESP) encryption transform using
Advanced Encryption Standard (AES) 128-bit encryption.
esp-aes192 Encapsulating Security Payload (ESP) encryption transform using
Advanced Encryption Standard (AES) 128-bit encryption.
esp-aes256 Encapsulating Security Payload (ESP) encryption transform using
Advanced Encryption Standard (AES) 256-bit encryption.
esp-des Encapsulating Security Payload (ESP) encryption transform using
Data Encryption Standard (DES) 56-bit encryption.
esp-3des Encapsulating Security Payload (ESP) encryption transform using
Data Encryption Standard (DES) 168-bit encryption.
esp-null Encapsulating Security Payload (ESP) encryption transform using no
encryption.
esp-md5 Encapsulating Security Payload (ESP) encryption transform using
Message-Digest Algorithm 5 (MD5) authentication. Default.
esp-sha Encapsulating Security Payload (ESP) encryption transform using
Secure Hash Algorithm (SHA1) authentication. Default.
ipcomp IP Payload Compression Protocol (IPComp) compression.