Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Fax-Protocol; History

8-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer FXS Mode
fax-protocol
Use the Dial Peer fax-protocol command to configure the fax protocol.
Syntax: (config-dpeer-fxs)# fax-protocol {none|pass-through|t38}
Example: (config-dpeer-fxs)# fax-protocol none
Supported Platforms:
Adit 3104, Adit 3500, MSR
history
Use the history command to display commands that have been entered in this session. This command
can be entered in any configuration mode.
Syntax: (config-dpeer-fxs)# history
Example: (config-dpeer-fxs)# history
history
block-out-caller-id enable
call-wait-caller-id enable
call-waiting enable
calling-party-disc enable
codec preference 1 g729
history
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
none A Fax call would be treated as a normal voice call. Default.
pass-through Will cause the line to transmit in G.711 mode, with echo cancellation
and silence suppression disabled, on detection of Fax tone.
t38 Upon detection of a Fax tone on the port, will cause the gateway to
negotiate a T.38 session with its peer and if successful, will enter T.38
Fax-relay mode. Will dynamically consume a T.38 token for the
session.
Note: For the MSR, T.38 will be supported in a future release.