Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Session-Target

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 10-5
Configuration - Dial Peer VoIP Mode
no commands
no destination-pattern
Use the Dial Peer no destination-pattern command to remove a destination pattern. To set the
destination pattern, see destination-pattern command on page 10-2.
Syntax: (config-dpeer-voip)# no destination-pattern
Example: (config-dpeer-voip)# no destination-pattern
Supported Platforms:
Adit 3104, Adit 3500, MSR
no prefix
Use the Dial Peer no prefix command to remove the prefix of the phone number. To define a prefix,
see prefix command on page 10-6.
Syntax: (config-dpeer-voip)# no prefix
Example: (config-dpeer-voip)# no prefix 1303
Supported Platforms:
Adit 3104, Adit 3500, MSR
no session-target
Use the Dial Peer no session-target command to remove session target. To configure a session
target, see session-target command on page 10-6.
Syntax: (config-dpeer-voip)# no session-target
Example: (config-dpeer-voip)# no session target
Supported Platforms:
Adit 3104, Adit 3500, MSR