Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Configure Terminal; Copy Defaults

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-3
Privileged Mode
configure terminal
Use the configure terminal command to enter the configuration mode.
Syntax: # configure terminal
Example: adit 3500# configure terminal
adit 3500 (config)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
copy
copy defaults
Use the copy defaults command to restore default setting.
Syntax: # copy defaults running-config
Example: adit 3500# copy defaults running-config
Going to reboot!
Restarting system.
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
copy path
Use the copy path command to load a configuration saved on your computer to the Adit system.
Note: A TFTP server must be running on your computer.
Syntax: # copy path {source-path} running-config
Example: adit 3500# copy path tftp://192.168.1.100/a3500_config running-
config
adit 3500#Configuration restore: Success
WARNING: A reload is needed for changes to take effect.
Field Definition
source-path Enter the source path, in the form tftp://address/filename
address - Enter IP address of the TFTP server.
filename - Enter the name of the configuration file to load onto the
system.