Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Snmp-Server; Snmp-Server Community; Snmp-Server Enable

4-60 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
Example: (config)# service id 5 name test description desc1 protocol gre
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
snmp-server
The following are the commands to set the SNMP server configuration. To disable SNMP, see no snmp-
server command on page 4-50.
snmp-server community
Use the snmp-server community command to set the SNMP community name.
Syntax: (config)# snmp-server community community-name {ro|rw}
Example: (config)# snmp-server community communitytestname ro
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
snmp-server enable
Use the snmp-server enable command to enable SNMP on the system.
Syntax: (config)# snmp-server enable
Example: (config)# snmp-server enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
server-src-port Defines the server source/destination port. Syntax:
server-src-port {port|port-port|any} server-dst-port {port|port-
port|any}
server-src-port port - Enter the server source port to apply the service to.
port-port - Enter a range of ports to apply the service to.
any - Apply to any port.
server-dst-port port - Enter the server destination port to apply the service to.
port-port - Enter a range of ports to apply the service to.
any - Apply to any port.
Field Definition
community-name Enter the SNMP Community Name.
ro Read only - Set the community name to read only permission.
rw Read write - Set the community name to read and write permission.