Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Schedule-Availability; Shutdown; Sip-Alg

11-24 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Ethernet Interface Mode
schedule-availability
Use the Ethernet Interface schedule-availability command to apply a schedule rule to this interface. To
delete a schedule, see no schedule-availability command on page 11-22.
Syntax: (config-int-eth-{n})# schedule-availability time-range
schedule-id
Example: (config-int-eth-1)# schedule-availability time-range 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
shutdown
Use the Ethernet Interface shutdown command to set the Ethernet port down (Out-of-Service). Note:
This command is not allowed if you are in the Ethernet 1 mode. To set the Ethernet port up (In-Service),
see no shutdown command on page 11-22.
Syntax: (config-int-eth-{n})# shutdown
Example: (config-int-eth-2)# shutdown
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
sip-alg
Use the Ethernet Interface sip-alg command to enable SIP ALG on this interface. To disable SIP ALG,
see no sip-alg command on page 11-22.
Syntax: (config-int-eth-{n})# sip-alg enable
Example: (config-int-eth-1)# sip-alg enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
schedule-id Enter an existing schedule rule name. See time-range command on
page 4-62 to set the schedule-id