Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Metric; No Commands

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-13
Configuration - L2TPC Mode
metric
Use the L2TPC metric command to configure the Metric of the IP network on this interface.
Syntax: (config-l2tpc-{n})# metric metric
Example: (config-l2tpc-1)# metric 150
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no commands
no firewall
Use the L2TPC no firewall command to disable the configured firewall. To enable the firewall, see
firewall command on page 15-3.
Syntax: (config-l2tpc-{n})# no firewall
Example: (config-l2tpc-1)# no firewall
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip address
Use the L2TPC no ip address command to remove the IP address assigned to the port. To set the
Serial IP address, see ip address command on page 15-5.
Syntax: (config-l2tpc-{n})# no ip address address
Example: (config-l2tpc-1)# no ip address 192.168.1.100
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
metric Range is 0-255, with a default is 10.
Field Definition
address Enter the IP address to remove.