Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Page 356

15-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - L2TPC Mode
no ip default-route
Use the L2TPC no ip default-route command to disable the default route. To set the default IP
address, see ip default-route command on page 15-5.
Syntax: (config-l2tpc-{n})# no ip default-route
Example: (config-l2tpc-1)# no ip default-route
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf authentication
Use the L2TPC no ip ospf authentication command to disable the authentication method for this
serial interface. To enable the authentication type for this interface see ip ospf authentication
command on page 15-6.
Syntax: (config-l2tpc-{n})# no ip ospf authentication
Example: (config-l2tpc-1)# no ip ospf authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf authentication-key
Use the L2TPC no ip ospf authentication-key command to remove a password to be used by
neighboring routers, that are using OSPF’s simple password authentication.To assign a password,
see ip ospf authentication-key command on page 15-7.
Syntax: (config-l2tpc-{n})# no ip ospf authentication-key
Example: (config-l2tpc-1)# no ip ospf authentication-key
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf cost
Use the L2TPC no ip ospf cost command to reset the cost path to the default setting of 0. To define
the cost of sending a packet on this serial interface, see ip ospf cost command on page 15-7.
Syntax: (config-l2tpc-{n})# no ip ospf cost
Example: (config-l2tpc-1)# no ip ospf cost
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR