Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Local-Server

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-27
Global Configuration Mode
Global Configuration Commands
local-server
Use the local-server command to configure the local server entries. To delete a local server, see the no
local-server command on page 4-44.
Syntax: (config)# local-server id {name|new} {ip-address address
|hostname hostname} time-range {always|schedule-name} fwd-port
port service service-id
Example: (config)# local-server id Boulder-server ip-address 10.10.2.100
time-range always fwd-port 2 service 16777220
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
name Enter a name of the server.
new Select New to create a new local server.
address Enter an IP address of the local server.
hostname Enter a host name of the server.
always Set the time range to
schedule-name Enter a defined schedule to be applied to the server.
port Enter a forwarding port.
service-id Enter the service number to apply the rule to. Note: The Service ID
number is displayed with the show service command, on page 3-61