Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - History; Lease

7-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - DHCP Pool Ethernet Mode
history
Use the history command to display commands that have been entered in this session.
NOTE: This command can be entered in any configuration mode.
Syntax: (config-dhcp-eth-{n})# history
Example: (config-dhcp-eth-1)# history
end-address 192.168.1.250
lease 900
relay 192.168.1.120
start-address 192.168.1.1
subnet-mask 255.255.255.0
history
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
lease
Use the DHCP lease command to define the DHCP lease time, in minutes. This defines the lease
duration, or the length of time for which the IP address can be used before a lease renewal is required,
or if the address is no longer in use, it is automatically returned to the pool for reallocation.
Syntax: (config-dhcp-eth-{n})# lease time
Example: (config-dhcp-eth-1)# lease 120
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
time Enter the DHCP lease time. Range is 1 - 71582788 minutes, with a
default of 60.