Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - End; Exit

9-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer Trunk Mode
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file.
Syntax: (config-dpeer-trk)# end
Example: (config-dpeer-trk)# end
#
Supported Platforms:
Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-dpeer-trk)# exit
Example: (config-dpeer-trk)# exit
(config)#
Supported Platforms:
Adit 3500, MSR
fax-protocol
Use the Dial Peer fax-protocol command to configure the fax protocol.
Syntax: (config-dpeer-trk)# fax-protocol {none|pass-through|t38}
Example: (config-dpeer-trk)# fax-protocol none
Supported Platforms:
Adit 3500, MSR
Field Definition
none A Fax call would be treated as a normal voice call. Default.
pass-through Will cause the line to transmit in G.711 mode, with echo cancellation
and silence suppression disabled, on detection of Fax tone.
t38 Upon detection of a Fax tone on the port, will cause the gateway to
negotiate a T.38 session with its peer and if successful, will enter T.38
Fax-relay mode. Will dynamically consume a T.38 token for the
session.
Note: For the MSR, T.38 will be supported in a future release.