Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Host-Filter; Interface Ethernet; Port

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-19
Global Configuration Mode
Global Configuration Commands
host-filter
Use the host-filter command to configure the IP/host name filtering entries. To delete a host filter, see
no host-filter command on page 4-40.
Syntax: (config)# host-filter id filter-id {ip-address address|hostname
hostname} apply-to {lan|network-object object-id} time-range
{always|schedule-id}
Example: (config)# host-filter id filterID ip-address 192.168.1.100
apply-to lan time-range always
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
interface ethernet
Use the interface ethernet command to allow access to the Ethernet interface configuration commands.
See Chapter 11, Configuration - Ethernet Interface Mode for commands in this mode.
Syntax: (config)# interface ethernet port
Example: (config)# interface ethernet 1
(config-int-eth-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
filter-id Enter a filter ID name.
address Enter the host IP address.
hostname Enter a host name for the rule.
lan Apply the filter the LAN interface.
network-object
object-id
Apply the filter to a defined network object.
always Set the time range to always.
schedule-id Enter defined schedule ID name with schedule to apply to this filter.
Field Definition
port Ethernet port. Range 1-2.