Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Show Interface Stats

2-16 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
User Mode
show interface stats
Use the show interface stats command to display the interface statistics.
Syntax: > show interface stats
Example: Adit 3500> show interface stats
Device=T1 1 State=up Dependency=None Status: Connecting (Alarm Condition)
Device=T1 2 State=up Dependency=None Status: Connecting (Alarm Condition)
Device=T1 3 State=running Dependency=None Status: Connected
Device=T1 4 State=running Dependency=None Status: Connected
Device=Serial 1 State=down IP/Mask=0.0.0.0/255.255.255.255 Dependency=T1 1 Status: Disconnected
Device=Ethernet 2 State=disabled IP/Mask=192.168.2.10/255.255.255.0 Dependency=None
Device=Ethernet 1 State=running IP/Mask=192.168.1.35/255.255.255.0 Dependency=None Status: Connected; Link: 10T-HD
Tx (Packets/Bytes/Dropped/Errors)=(2362/2498024/0/0)
Rx (Packets/Bytes/Dropped/Errors)=(2211/210493/0/0)
Broadcasts (Tx/Rx)=(0/0) Multicasts=0 Collisions=0
Device=IPsec 0 State=disabled IP/Mask=0.0.0.0/0.0.0.0 Dependency=Serial 1
Device=IPsec 1 State=running IP/Mask=192.168.1.35/255.255.255.0 Dependency=Ethernet 1Status: Connected
Tx (Packets/Bytes/Dropped/Errors)=(0/0/0/0)
Rx (Packets/Bytes/Dropped/Errors)=(0/0/0/0)
Example: Adit MSR> show interface stats
Device=LinkCC 1 State=running
Dependency=None
Status: Operational
Device=LinkCC 2 State=running
Dependency=None
Status: Operational
Device=LinkCC 3 State=down
Dependency=None
Status: Unassigned
Device=LinkCC 4 State=down
Dependency=None
Status: Unassigned
Device=LinkCC 5 State=down
Dependency=None
Status: Unassigned
Device=LinkCC 6 State=down
Dependency=None
Status: Unassigned
Device=LinkCC 7 State=down
Dependency=None