Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 14-13
Configuration - IPSec Mode
no encryption
Use the IPSec no encryption command to disable encryption. To configure encryption, see encryption
command on page 14-5.
Syntax: (config-ipsec-{n})# no encryption {des|3des|aes|aes192| aes256}
Example: (config-ipsec-1)# no encryption aes
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no group
Use the IPSec no group command to disable a Diffie-Hellman (DH) group identifier. To set a DH group
identifier, see group command on page 14-6.
Syntax: (config-ipsec-{n})# no group {1|2|5}
Example: (config-ipsec-1)# no group 2
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
des Disable 56-bit Data Encryption Standard (DES).
3des Disable 168-bit DES. Default.
aes Disable 128-bit Advanced Encryption Standard (AES) as the
encryption algorithm.
aes192 Disable 192-bit AES as the encryption algorithm.
aes256 Disable 256-bit AES as the encryption algorithm.
Field Definition
1 Disable DH group 1 (768 bit).
2 Disable DH group 2 (1024 bit). Default is enabled.
5 Disable DH group 25 (1536 bit). Default is enabled.
To Next Page
Loading...