Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Page 220

8-2 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer FXS Mode
block-out-caller-id
Use the Dial Peer block-out-caller-id command to enable the blocking of outgoing Caller ID. To
disable blocking, see no block-out-caller-id command on page 8-8.
Syntax: (config-dpeer-fxs)# block-out-caller-id enable
Example: (config-dpeer-fxs)# block-out-caller-id enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
call-wait-caller-id
Use the Dial Peer call-wait-caller-id command to enable Call Waiting and Caller ID. To disable these
calling features, see no call-wait-caller-id command on page 8-8.
Syntax: (config-dpeer-fxs)# call-wait-caller-id enable
Example: (config-dpeer-fxs)# call-wait-caller-id enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
call-waiting
Use the Dial Peer call-waiting command to enable Call Waiting. To disable Call Waiting, see no call-
waiting command on page 8-8.
Syntax: (config-dpeer-fxs)# call-waiting enable
Example: (config-dpeer-fxs)# call-waiting enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
calling-party-disc
Use the Dial Peer calling-party-disc command to enable Calling Party Disconnect. To disable this
feature, see no calling-party-disc command on page 8-8.
Syntax: (config-dpeer-fxs)# calling-party-disc enable
Example: (config-dpeer-fxs)# calling-party-disc enable
Supported Platforms:
Adit 3104, Adit 3500, MSR