11-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Ethernet Interface Mode
no ip ospf priority
Use the Ethernet Interface no ip ospf priority command to set the router priority to the default
setting of priority 1. To set the router priority, which determines the designated router for this
network, see ip ospf priority command on page 11-12.
Syntax: (config-int-eth-{n})# no ip ospf priority
Example: (config-int-eth-1)# no ip ospf priority
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf retransmit-interval
Use the Ethernet Interface ip ospf retransmit-interval command to restore the default value of 5
seconds. To define the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface, see ip ospf retransmit-interval command on page 11-12.
Syntax: (config-int-eth-{n})# no ip ospf retransmit-interval
Example: (config-int-eth-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf transmit-delay
Use the Ethernet Interface no ip ospf transmit-delay command to restore the default value of 1
second. To define the estimated time to transmit a link state update packet on the interface, see ip
ospf transmit-delay command on page 11-12.
Syntax: (config-int-eth-{n})# no ip ospf transmit-delay
Example: (config-int-eth-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip primary-dns
Use the Ethernet Interface no primary-dns command to disable the primary DNS. To set the DNS
primary IP address, see ip primary-dns command on page 11-13.
Syntax: (config-int-eth-{n})# no ip primary-dns
Example: (config-int-eth-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
To Next Page
Loading...