22-2 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Mode
digit-map (global)
Use the Voice Port digit-map global command to configure the Digit Map on a global level. To disable
digit map, see no digit-map (global) command on page 22-5.
Syntax: (config-vport)# digit-map mode {long-timeout seconds |pattern
number pattern |short-timeout seconds}
Example: (config-vport)# digit-map mode long-timeout 20
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
long-timeout
seconds
Range is 4-60 seconds, with a default of 16.
pattern number - Enter pattern number to modify. Range is 1-30.
See show digit-map command on page 3-37, to display the current list
of Digit Map numbers.
pattern - Enter the new pattern, with a maximum of 30 characters.
short-timeout
seconds
Range is 1-10 seconds, with a default of 4.
To Next Page
Loading...