Station Group Assign (PGM 190/191) 2-99
Chapter 2: SBX IP Offline PCAdminPro
SBX IP - PC Admin Guide
VMIB Announce
Location 2
00-70 00 (not
assigned)
This location is used to announce greeting when the
VMIB Announce 2 timer expires.
VMIB Announce 2 Repeat
Timer
000-999 000
(sec)
The VMIB announce 2 is repeated when this timer expires
(000 = not assigned).
VMIB Announce 2 Repeat
Enable/Disable
ON/OFF OFF This is used to enable or disable the VMIB Announce 2
Repeat.
Overflow Destination Sta #./
HUNT #./
VMIB #/
SYS SPD
#
-- The call to a station in the group will continue to route until
answered or each station in the group has been tried. The
call will remain at the last station in the group or will be
passed to this overflow station/group/VMIB.
Overflow Timer 000-600 180
(sec)
If this timer expires after a call comes into the group, the
call is routed to the overflow destination.
Wrap-up Timer 002-999 002
(sec)
A station in a hunt group is maintained in a busy state for
a minimum of six seconds after any call and for hunt group
calls for the assigned wrap-up time.
Alt if no Member ON/OFF OFF If there is no member on duty, an ICM call will be dropped
or an incoming CO call will be routed to the Attendant.
Music Source 0-9 0 (not
assigned)
If music source is assigned, calling user will be heard
music instead of ring back tone.
0: Not Assigned 1: Internal Music
2: External Music 1 3: Reserved
4: SLT 1 5: SLT 2
6: SLT 3 7: SLT 4
8: SLT 5 9: Hold Tone
UCD Warning Tone ON/OFF ON Establishes whether the ACD supervisor monitors an
agent with a warning tone or without a warning tone
Alternate Destination Sta No/
Hunt No
-- When a call comes into the group and there is no
available station in the group, then the call will be routed
to this destination, if assigned.
Supervisor Timer 000-999 030
(sec)
When the queued time is longer than this timer, the
number of queued lines will be displayed on the
supervisor's LCD.
UCD Group Attributes (PGM 191)
ITEM RANGE DEFAULT REMARK
To Next Page
Loading...
