Chapter 10 Troubleshooting 40058725 BTA Alpha HSM
Version: 12.19.17 Page 108 of 112 GB
Warnings
Initialisation phase
After switching on, this message indicates the operating state of the labeler during the ini-
tialization phase.
Label number reached
This message indicates that the "Countdown" function has run to the end and has
reached the end value "000".
Low label reached
This message indicates that the pre-set minimum diameter of the label roll for optional low
label warning has been reached. When the residual label length (machine parameter [025]
has been entered, the labeling mode is continued until this value has been reached.
Thereafter, the labeler will stop and the "Web end reached” error message will be dis-
played.
LAN-link time-out
This message can only occur in the Zero Down Time mode.
The message means that no network connection is found. A potential cause is the lack of
a labeler signal for the ZeroDownTime function.
ZeroDownTime parameter
This message can only occur in the Zero Down Time mode.
The ZeroDownTime function requires that the machine parameters [002] and [003] as well
as the entries on the "Speed control" menu page are the same for both labelers.
The message means that the parameters differ from each other.
To Next Page
Loading...