Chapter 6 Installation and connection 40058725 BTA Alpha HSM
Version: 12.19.17 Page 34 of 112 GB
6. Installation and connection
Safety instructions
Danger through a direct or indirect contact with live parts.
If persons come into contact with parts that have become ener-
gized through malfunctions, this can lead to death.
- Work on electrical equipment may only be performed by
skilled electricians.
- Check the electrical equipment of the labeler regularly.
- Immediately eliminate loose connections or damaged cables.
- Always keep the switching cabinet closed.
- Before working on electrical equipment, switch the main
switch to the "0" position, and secure it against accidental re-
activation. If possible, disconnect from the mains.
Danger from highly flammable label stock.
Foil and label stock are highly flammable. Risk of injury from fire
and smoke.
- Keep away from ignition sources and open flames.
Hazards from moving parts.
Entanglement and risk of being crushed through pneumatically or
mechanically-powered labeler components.
Movements or rotations can start suddenly and abruptly in label-
ing mode.
- Do not reach into, towards or between moving parts.
- Only wear tight-fitting clothing with tight sleeves and a low ten-
sile strength.
- Wear a safety hair net
- Do not wear any jewellery, bracelets, watches or similar.
To Next Page
Loading...