Chapter 2 Safety regulations 40058725 BTA Alpha HSM
Version: 12.19.17 Page 18 of 112 GB
Protective devices
Danger points can develop at the transition areas of the customer-side conveying sys-
tems. Appropriate protection measures according to the machinery directive 2006/42/EG
must be implemented.
Separating and non-separating protective devices
The labelling system doesn't require any additional protective device for the operation.
The installation of additional protective devices is the operator's responsibility, and must
comply with the Machinery Directive 2006/42/EC.
Warning notices on the labeler
Special sources of danger on the labeler are marked with yellow stickers. The pictograms
used indicate hazards and, if applicable, also notes to be observed.
Do not remove pictograms.
Replace missing or illegible pictograms.
Danger to life from electrical current
Danger from strong light radiation
Observe the operating instructions
Do not adjust the throttle valve
To Next Page
Loading...