Weber Alpha HSM User Manual

Chapter 9 Maintenance and repair 40058725 BTA Alpha HSM
Version: 12.19.17 Page 93 of 112 GB
Recommended cleaning agents
Unsuitable cleaning agents can cause damage to the ma-
chine.
- Do not use cleaning agents that could damage material sur-
faces or electrical components, etc. Observe the instructions
of the cleaning agent manufacturer.
- Do not use abrasive or plastic-soluble cleaning agents.
- Do not use acidic or alkaline solutions.
Use our cleaning set, item no. 21800981 for cleaning work.
Cleaning instructions are included with the cleaning kit (item number 22800512). This pro-
vides detailed information about the required cleaning work, as well as further information
about the safe use of cleaning agents.
Daily maintenance/repair (after approx. 8 operating hours)
Prerequisites
 Labeler is separated from the voltage and compressed air.
 No product handling.
Tools required
 Label remover (* 21800771)
 Alcohol (* 21800915) or roller cleaner (* 21800977)
 Lint-free cloth (* 21800978)
* Product recommendation! Can be obtained from the Bluhm Weber Group using the 8-digit item number.
Instruction
How to perform the daily maintenance/repair.
Step
Approach
1
Clean the drive roller with a roller solvent on a daily basis or after changing
the label roll. For this, spray some roller solvent onto a lint-free cloth and
wipe down the rubber roller. Wait until the drive roller is completely dry, be-
fore you reinstall the label liner.
2
Check label guides and deflection rollers, as well as the peel bar for any
adhesive deposits / labels (residue). Remove them with label remover or
alcohol.
Spray a cleaning cloth with label remover (alcohol) and wipe all surfaces
carefully with it.
Carefully spray stubborn deposits with a label remover. The exposure time
for PE (polyethylene) labels is significantly longer than for paper labels and
can be between 1 and 10 minutes. Remove the label residue and wipe down
with the cleaning cloth.
3
If present, check the water separator of the compressed air connection.
Drain it by opening the release valve on the bottom.
.

Weber Alpha HSM Specifications

General

Brand	Weber
Model	Alpha HSM
Category	Printer Accessories
Language	English