Chapter 2 Safety regulations 40058725 BTA Alpha HSM
Version: 12.19.17 Page 15 of 112 GB
Intended use
The operation reliability of the labeler is only guaranteed when used as intended.
An intended use will be considered as such, if …
the labeler is exclusively used for automatic labeling of moving or stationary prod-
ucts.
the labeler is only operated only within its rated performance range (see “Technical
Specifications”).
manual operations can only be carried out on the labeler when it is stopped.
the labeler is used for the specified products which have been agreed upon with
the customer and with the labels which have also been specified and agreed upon.
The products and labels must correspond to the specifications *documented and
agreed upon between the machine manufacturer and the customer.
* "Documented specifications" are usually set out in the SAD (System Application Description) which are provided
to the customer with the order confirmation.
the labeler is used in a non-explosive environment. (No EX protection suitability!).
the labeler does not come into direct contact with foodstuffs.
the labeler is not used for outdoor applications.
the labeler is only used in the EU (European Union) and only in the industrial sec-
tor.
the working conditions prescribed in these operating instructions and
guidelines are observed.
Faults on the labeler which could affect the safety must be reported immediately
and also immediately eliminated by qualified and trained personnel.
maintenance is carried out properly.
the labeler is only operated in perfect condition.
protective devices are not bypassed or deactivated.
no arbitrary changes are made to the machine.
the labeler is only operated and handled by suitable personnel, see "Approved
persons" (see page 21). These people must have read and understood the operat-
ing instructions.
Any use of the labeler which does not comply with one of these points is considered as
improper and can lead to serious property damage and personal injury.
To Next Page
Loading...