Chapter 1 General 40058725 BTA Alpha HSM
Version: 12.19.17 Page 13 of 112 GB
Contact-free application mode, during which the dispensing
tamp takes over the printed label through vacuum, conveyed
to the product and blown onto the product
Application mode, during which the dispensing tamp takes
over the label through vacuum, conveys it to the product and
presses it onto the product.
The trailing edge of a product/label is used to start a process
(also refer to “Edge detection”).
The signal from a sensor or a PLC that is used to activate an
application process.
Support of the label roll (usually for 3-inch cardboard core).
Unwinding enables a smooth, jerk-free unwinding (decoiling)
of the label roll, and is metered through a roller brake (also
see the dancer arm). Unwinders can also have a motor drive.
Label liner, consisting of a siliconized backing tape and the
adhesive labels.
labeling process, during which the label is detached through
a peeler plate and passed directly onto the product. Label
advancement and product speed must be identical.
To Next Page
Loading...
Need help?
General