Disassembly and Assembly: Fan Failure Card
Issue 2
129
Part No. 306-0430-102
Fan Failure Card
Removal
The fan failure card is located in the electronics compartment, with two temperature sensors protruding into the
filter compartment, just below the fan filter.
1
Disconnect the FAN FAIL connector from its location at bottom centre of the I/O board.
2
Remove and retain the nylon screw securing the fan failure card. The screw is located in the filter
compartment, below the fan filter.
3
The fan failure card can now be removed from the electronics compartment.
Installation
1
Place the card in position with the temperature sensors protruding in to the filter compartment.
2
Secure the card with the nylon screw removed at
Removal
step
2
.
3
Connect the FAN FAIL connector to the I/O board.
To Next Page
Loading...
