Consumables: Ink and Solvent Storage
Issue 2
15
Part No. 306-0430-102
C
ONSUMABLES
The table below lists the available ink, top-up, washdown and FIN numbers for the 430 Series.
Ink Top-Up Washdown Fluid Identification No.
MK 3901D BLACK 201-0001-601 201-0001-401 201-0001-702 110/110/47/32/35
MK 3903F RED 201-0001-603 201-0001-402 201-0001-705 120/120/43/32/35
MK 3930F BLACK 201-0001-630 201-0001-401 201-0001-702 094/088/58/32/35
EA 3969H BLACK 201-0001-669 201-0001-413 201-0001-755 093/090/54/32/35
Table 2 430 Range of Inks
Ink and Solvent Storage
You must follow the precautions listed below for ink and solvent storage:
•
All inks and solvents should be stored and used in a well-ventilated area and protected in case of fire.
•
Store and ship the inks and solvents out of direct sunlight within the temperature range 5°C to 50°C.
•
When shipping inks or solvents, comply with the local laws and regulations.
•
The risk of fire is an important consideration when storing/shipping inks and solvents. Aqueous inks and
solvents present a low fire risk as they will not burn or support combustion. Inks based on water/alcohol
mixtures may burn if sufficient alcohol is present. Solvent-based inks pose a greater fire risk. Consult the
appropriate product data sheet on the exact nature of the ink/solvent.
•
Use powder or dry foam to extinguish fires and ensure electrical supply is turned off. A fire blanket may be
used to smother small local fires. If in doubt consult the local fire authority.
•
Wipe up any spillage immediately with absorbent material and dispose of safely. If spillage is large, ventilate
the area.
•
Dispose of ink and solvents in accordance with the local regulations.
•
Do not dispose of inks and solvents into the local drains.
WARNING - HANDLING INK, SOLVENT AND TOP-UP
The ink, solvent and top-up are irritating to the eyes and respiratory system. To prevent
personal injury when handling these substances:
Always wear protective clothing and rubber gloves.
Always wear goggles with side-shields or a face mask. It is also advisable to wear safety
glasses when carrying out maintenance.
Apply barrier hand cream before handling ink.
If ink or top-up contaminates the skin, wash immediately with soapy water. DO NOT use
washdown or solvent to clean ink stains from the skin.
To Next Page
Loading...
