Technical Description: Cabinet
Issue 2
47
Part No. 306-0430-102
Side Covers
The two side covers (
9
) are similar, they have different length fasteners fixed to them, thus they require the
correct orientation when fitting. The side covers should be fitted with the long fasteners at the opposite side from
the printhead umbilical cable.
The covers are secured using quick release fasteners (
6
) which have combined slotted/pozi-heads to facilitate
removal. When the covers are removed the fasteners are retained in the cover by captive plastic washers.
Base
The base (
10
) is moulded from plastic and houses the following:
The ink system filters (see
Ink System Filters
, page 82) and the electronic system cooling fan filter.
A hinged cover (
8
), which gives access to the ink system filter and the electronic system cooling fan filter.
The connector panel (
7
) (see
Connector Panel
on page 53).
The printhead umbilical outlet (
11
).
To Next Page
Loading...
