EasyManua.ls Logo

wsm M7060 - Page 164

wsm M7060
639 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGINE
M6060, M7060, WSM
1-S3
9Y1210828ENS0001US0
The lubricant oil
consumption is too
much
The gap of the piston ring points to the same
direction
Move the ring gap
direction
1-S52
The oil ring is worn out or cannot move Replace 1-S53
The piston ring groove is worn out Replace the piston
and piston ring
1-S70
The valve stem and valve guide are worn out Replace 1-S40,
1-S58
The crankshaft bearing and the crank pin bearing
is worn out
Replace 1-S72,
1-S73
The fuel is mixed into
the lubricant oil
The injector is damaged Replace 1-S35
Fuel leak from the overflow pipe of the inner
cylinder head cover
Replace the gasket 1-S36
Oil dilution due to regeneration Change the engine oil G-22
Water is mixed into
the lubricant oil
The head gasket is damaged Replace 1-S38,
1-S39
The cylinder block or cylinder head is damaged Replace 1-S38
The oil pressure is
low
The engine oil is not sufficient Fill oil to the specified
amount
G-22
The oil strainer is clogged Clean 1-S51
The relief valve does not operate with dirt Repair or replace 1-S45
The oil clearance of the bearings are too much Replace the metal,
bushing or shaft
1-S52,
1-S54,
1-S72,
1-S73
The oil passage is clogged Clean
The type of oil used is incorrect Use the specified type
of oil
G-14
The oil pump is damaged Replace 1-S76
The oil pressure is
high
The type of oil used is incorrect Use the specified type
of oil
G-14
The relief valve is damaged Repair or replace 1-S45
The engine is
overheated
The engine oil is not sufficient Fill oil to the specified
amount
G-22
The fan belt is broken or the fan belt tension is
too loose
Replace or adjust 1-S14
The coolant is not sufficient Fill to the specified
amount
G-40
The radiator net and the radiator fin are clogged
with dust
Clean
There is corrosion in the inner side of the radiator Clean or replace G-40
There is clogged in the coolant flow route Clean or replace G-31
The radiator or radiator cap is damaged Replace 1-S15
The load is too much Reduce the load
The head gasket is damaged Replace 1-S38
The fuel used is incorrect Replace the specified
fuel
G-14
Symptom Probable Cause Solution
Reference
Page
KiSC issued 08, 2013 A

Table of Contents

Related product manuals