April 2010
4-52
Phaser 3635MFP/WorkCentre 3550
ADJ 8.2
Repairs and Adjustments
5. Measure the distance between the left edge of the paper and the ADG line on the printed
test pattern,
Figure 1.
Figure 1 Test pattern 7
6. If the distance measured is not 12.7mm (0.5 inch) +/-2.5mm, perform the Adjustment.
Adjustment
1. Select Exit (on the dC606 Internal Print Test Patterns (3635 Only).
2. Select Diagnostic Routines.
3. Select Copier Routines.
4. Select 131 NVM Read Write.
5. Refer to Table 1. Select the relevant NVM setting.
6. Select Read/Write. Enter a new value as follows:
• To increase the side edge registration (move the ADG line away from the paper
edg)e, enter a value larger than the current value.
• To decrease the side edge registration (move the ADG line toward the paper edg)e,
enter a value smaller than the current value.
NOTE: A change of 12 will change the registration by approximately 6mm (0.24
inch)
7. Save the adjustment.
a. Select Save.
b. Select OK.
8. Prepare to check the adjustment.
a. Select Close.
b. Select Diagnostic Routines.
c. Select Other Routines.
9. Perform again the 3635 Checkout.
3550 Checkout
NOTE: Both the Check and the Adjustment use an internal test pattern. Both are performed in
diagnostics.
Check the side edge registration (left side edge of portrait A4 or 8.5x11 inch). Perform the fol-
lowing:
1. Enter diagnostics GP 1 Diagnostics Entry.
2. Select machine diagnostics.
3. Select dC606 Internal Print Test Patterns (3635 Only).
4. Select Test Pattern 7 for simplex side edge check or select Test Pattern 15 for duplex
side edge check.
5. Press the O.K button to print the chosen test pattern.
NOTE: Simplex copies exit face down. Duplex copies exit side 1 face down (side 2 face
up).
Table 1 NVM location
Mode Tray Location
Simplex 1 07-110
Simplex 2 07-210
Simplex Bypass 07-510
Duplex Side 1 1 07-150
Duplex Side 1 2 07-250
Duplex Side 1 Bypass 07-550
Duplex Side 2 1 07-130
Duplex Side 2 2 07-230
Duplex Side 2 Bypass 07-530
Table 1 NVM location
Mode Tray Location
To Next Page
Loading...
