April 2010
4-53
Phaser 3635MFP/WorkCentre 3550
ADJ 8.2
Repairs and Adjustments
6. Measure the distance between the left edge of the paper and the ADG line on the printed
test pattern,
Figure 2.
Figure 2 Test pattern 7
7. If the distance measured is not 12.7mm (0.5 inch) +/-2.5mm, perform the Adjustment.
Adjustment
1. Select Exit (on the dC606 Internal Print Test Patterns (3635 Only).
2. Select Diagnostic Routines.
3. Select Copier Routines.
4. Select 131 NVM Read Write.
5. Refer to Table 2. Select the relevant NVM setting.
6. Select Read/Write. Enter a new value as follows:
• To increase the side edge registration (move the ADG line away from the paper
edg)e, enter a value larger than the current value.
• To decrease the side edge registration (move the ADG line toward the paper edg)e,
enter a value smaller than the current value.
NOTE: A change of 12 will change the registration by approximately 1mm (0.04
inch)
7. Press the O.K button to save the adjustment.
8. Exit diagnostics GP 1 Diagnostics Entry.
9. Perform again the 3550 Checkout.
Table 2 NVM location
Mode Tray Location
Simplex 1 07-110
Simplex 2 07-210
Simplex Bypass 07-510
Duplex Side 1 (Long
and short)
1 07-150
Duplex Side 1 (Long
and short)
2 07-250
Duplex Side 1 (Long
and short)
Bypass 07-550
Duplex Side 2 (Long) 1 07-130
Duplex Side 2 (Long) 2 07-230
Duplex Side 2 (Long) Bypass 07-530
To Next Page
Loading...
