0-3
GEN
INFO
General information
Special service tool
Use the recommended special service tools
to work safety, and to protect parts from dam-
age.
Tightening torque
Follow the tightening torque specifications
provided throughout the manual. When tight-
ening nuts, bolts, and screws, tighten the
large sizes first, and tighten fasteners starting
in the center and moving outward.
Non-reusable part
Always use new gaskets, seals, O-rings, cot-
ter pins, circlips, and so on, when installing or
assembling parts.
Disassembly and assembly
• Use compressed air to remove dust and dirt
during disassembly.
• Apply engine oil to the contact surfaces of
moving parts before assembly.
• Install bearings with the manufacture identi-
fication mark in the direction indicated in
the installation procedure. In addition, be
sure to lubricate the bearings liberally.
• Apply a thin coat of water-resistant grease
to the lip and periphery of an oil seal before
installation.
• Check that moving parts operate normally
after assembly.
To Next Page
Loading...
