3-8
Mounting the rigging grommet
0
1
2
3
4
5
6
7
8
9
10
A
TIP:
The second hole from the clamp bracket top
is recommended for the upper mounting bolt.
6. Secure the bolts, and firmly tighten the
nut to the extent that the clamp bracket
does not bite into the boat transom.
7. Firmly tighten the locknuts.
Mounting the rigging grommet
Rigging grommet description
a Main wiring harness
b Water temperature lead (option)
c Water pressure hose (option)
d Isolator lead (option)
e Battery cable
f Gauge harness
g Fuel hose
h Speedometer hose
i Shift cable
j Throttle cable
Installing the shift cable
Always perform the cable adjustment in
advance, following the procedures in the
remote control operation manual.
1. Remove the rubber seal a at the retain-
ing plate b portion.
Boat transom
thickness (D)
Mounting bolt
55–65 mm
(2.17–2.56 in)
M12 × 115 mm
(4.53 in)
65–75 mm
(2.56–2.95 in)
M12 × 130 mm
(5.12 in)
75–95 mm
(2.95–3.74 in)
M12 × 150 mm
(5.91 in)
f
c
d
d
e
c
d
d
e
f
D
f
c
d
d
e
a
b
c
d
e
f
g
h
i
j
a
b
Outboard motor mount / Mounting the rigging grommet
To Next Page
Loading...
