3-9
RIG
GING
Rigging information
2. Remove the bolts c, and then remove
the retaining plate b.
3. Fully screw in the cable joint d to the
shift cable e.
4. Set the remote control lever in the N
position.
5. Open the clamp g of the shift cable
holder f.
TIP:
Shift cable position is adjustable by using the
shift cable holder f.
6. Pass the shift cable e through the
rigging grommet, fit the cable groove
onto the projection on the cable holder f
for installation.
7. Align the mark a on the bushing h with
the mark b on the plate i.
8. Adjust the cable joint d to the pin c of
shift lever. WARNING! The shift cable
joint must be screwed in a minimum
of 8.0mm (0.31in).
9. If the cable joint is not maintained the
engagement of minimum 8.0 mm
(0.31 in) d, remove the bolt j and
remount the holder with the hole e or f.
c
b
e
d
f
g
Dimension d: 8.0 mm (0.31 in)
e
e
f
a
b
h
i
d
d
c
d
To Next Page
Loading...
