3-13
RIG
GING
Rigging information
2. Install the extension hose d to the nipple
c, and then fasten it with the plastic tie
e.
TIP:
Cut the extension hose d to 300 mm
(11.8 in).
3. Install the tubes f and g.
TIP:
• Cut the tube f to 300 mm (11.8 in).
• Cut the tube g to 270 mm (10.6 in).
4. Connect the extension hose d to the
speed sensor adapter.
5. Remove the bracket h.
6. Install the speed sensor adapter i.
7. Install the speed sensor j onto the
speed sensor adapter i, and then
tighten the speed sensor to the specified
torque.
8. Remove the bracket h and cap k from
the speed sensor coupler b.
9. Connect the speed sensor coupler b to
the speed sensor j.
c
d
e
f
g
h
Speed sensor j:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
i
i
j
h
b
k
To Next Page
Loading...
