YASKAWA DX100 - Page 643

8Alarm
DX100 8.3 Alarm Message List
8-528
4550 CANNOT
EXECUTE
INST(USER JOB)
Sub Code: System number Setting error (1)Check the following settings.
·This instruction cannot be executed in the system job. Correct the job so that
the instruction is executed in the user job.
4551 CANNOT
MEASURE TIP
INSTALL COEF
Sub Code: Gun number Setting error (1)Check the following settings.
·Execute the "SVGUNCL TWC-AE", and then execute the "SVGUNCL
TWC=BE".
4565 SOFTWARE
UNMATCH
1 The multi-layer welding function is
not used.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
2 The observer function is not used. Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
3 The TURBO function is not used. Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4 The COMARC function is not
used.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
5 The conveyor/press
synchronization function is not
used.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy